Gutters do one job: catch the water coming off the roof and put it somewhere that will not hurt the house. On many older New Jersey homes they are no longer doing it. Sectional gutters leak at every seam, sag where the hangers have pulled out of tired fascia, or are simply too small for the roof above them. The result is water spilling over the front edge during summer downpours, soaking the fascia, and pooling against the foundation, which is how a gutter problem becomes a wet-basement problem in parts of Essex, Union and Middlesex counties.
We install seamless aluminum gutters formed on site to the exact length of each run, so the only joints are at the corners. Sizing matters: a standard 5-inch K-style gutter suits most single-story roofs, while larger or steeper roofs and long two-story runs often need 6-inch gutters with 3x4-inch downspouts to keep up with a heavy storm. We set the pitch toward each outlet, fasten with hidden hangers into solid fascia, and route the downspouts with extensions so the water lands well away from the foundation.
Gutter installation is easiest to get right when the roof is being replaced or installed at the same time. With the old roof off, we can fit new drip edge so it laps into the gutter correctly and replace any rotted fascia board before the gutters go up. If you are planning a roof replacement, adding gutters to the same project saves a second setup and makes sure the two systems meet cleanly. If leaves are the main problem at your house, pair new gutters with gutter guards.
Technician insight
When gutters keep pulling away on an older New Jersey house, the hangers are rarely the real problem. It is usually soft fascia behind them, and new gutters on rotted wood will sag again within a couple of winters.
Gutter Upgrade During a Roof Replacement
A colonial had sagging sectional gutters and water pooling by the foundation. With the roof off for replacement, rotted fascia boards were replaced, new drip edge was fitted, and 6-inch seamless gutters were hung with oversized downspouts and extensions, carrying water well clear of the foundation.
Gutter Installation Services We Offer
✓Seamless Aluminum Gutters
Gutters formed on site to the exact length of each run, with joints only at the corners.
✓6-Inch Oversized Gutters
Extra capacity for large, steep or two-story roofs that overflow standard 5-inch gutters in heavy rain.
✓Downspout Installation
Downspouts sized and placed to drain each run, with extensions that carry water away from the foundation.
✓Gutter Replacement
Removal of old sectional or sagging gutters and installation of a new seamless system.
✓Fascia Board Replacement
Rotted fascia replaced before new gutters are hung, so the hangers have solid wood to grip.
Gutter Installation Cost in New Jersey
| Service | Typical Range | What Affects It |
|---|---|---|
| Seamless aluminum gutters installed | $8–$15 per linear foot | 5-inch vs 6-inch and one- vs two-story |
| Downspouts | $150–$400 each | Length, size and routing |
| Full gutter replacement (typical home) | $1,200–$3,500 | Home size, number of stories and corners |
| Fascia board replacement | $10–$25 per linear foot | Only where the existing board is rotted |
Ranges are typical for New Jersey and confirmed with an exact written quote before any work starts.
How it works
- 1
Measure and Assess
We measure every run, check the fascia and note where water currently overflows or pools.
- 2
Written Estimate
You get an itemized estimate covering gutter size, downspouts, any fascia repair and optional guards.
- 3
Installation
Gutters are formed on site, pitched to the outlets, fastened with hidden hangers and connected to new downspouts.
- 4
Water Test and Cleanup
We run water through the system to confirm flow at each downspout, then clear the site.
Pricing
Seamless gutter installation in New Jersey is usually priced by the linear foot; gutter size, home height and the number of downspouts move the total.